News

Location: Home > News
    What are the requirements of the environment of CNC lathe?
    Publisher:yuhuanqunfa       Release time:2019/1/26

    The normal use of CNC lathe equipment must meet the following conditions, the power supply voltage of the machine tool's position is small, and the environment temperature is less than 30 degrees, and the relative temperature is less than 80%.
    1, environmental requirements, the position of the machine tool should be away from the local oscillator, should avoid direct sunlight and heat radiation effect and avoid the influence of moisture and air. Such as machine tool near the source, the machine tool should be set around the anti vibration ditch. Otherwise it will directly affect the machining accuracy and stability of the machine tool, will make the electronic components contact, failure, the impact of the reliability of the machine tool.
    2, the power requirements of the general CNC lathe installed in the machining workshop, not only the environment temperature change, the use of poor conditions, but also a variety of mechanical and electrical equipment, resulting in large fluctuations in the power grid. Therefore, the installation of CNC lathe position, the need for strict control of the supply voltage. Power supply voltage fluctuations must be within the allowable range and remain relatively stable. Otherwise it will affect the normal operation of CNC system.
    3, the temperature condition of the numerical control lathe environment temperature is lower than 30 degrees, the relative temperature is less than 80%. Generally speaking, the inside of the numerical control electric control box is provided with a fan or a cold air blower, so as to keep the electronic components, especially the central processing unit, the working temperature of the central processor is constant or the temperature difference is small. Excessive temperature and humidity will lead to lower life expectancy of the control system components, and lead to an increase in the number of failures. The increase in temperature and humidity, the dust will increase in the integrated circuit board production, and lead to a short circuit.
    4, regulate the use of machine tools in the use of machine tools, the control system is not allowed to change the parameters of the control system set. The setting of these parameters is directly related to the dynamic characteristics of the components of the machine tool. Only the gap compensation parameters can be adjusted according to the actual conditions. The user can not easily replace the machine tool accessories, such as the use of beyond the specification of hydraulic chuck. When setting the accessories, the manufacturing plant fully consider the matching of the parameters of each link. Blind replacement of the link parameters do not match, and even lead to an estimated accident. The use of hydraulic chuck, hydraulic cutter, hydraulic tailstock, hydraulic cylinder pressure, should be in the allowable stress range are not allowed to arbitrarily raise.

     
天天看影院_天天看电影_av天天看